How do you cut laminate worktops?

To cut through laminate countertops, you can use a hand saw, but a circular saw makes the job much quicker. Because a circular saw can produce jagged edges and chip the laminate, your best bet is to lay the laminate face-side down and cut from the back to the front.

circular saw

Also, can you cut laminate worktop with a jigsaw? Fitting laminate panels seamlessly requires the cleanest of cuts. If you are cutting from the laminate side of the workpiece, you will want to avoid using ordinary jigsaw blades. The usual jigsaw blade has teeth pointing upwards that cut on the upstroke, and they could rip up and crack the decorative laminated layer.

Subsequently, question is, what tool do you use to cut laminate countertops?

circular saw

How can I cut my worktop without chipping?

Cut kitchen worktop. When cutting a kitchen worktop it is best if you cut it upside down, this is because the teeth on the blade cut on the way up, so there is much less chance of chipping the worktop. Some people draw a line on the worktop and then score it a few times using a sharp knife, then apply some masking tape

How do you cut laminate Upstands?

Installing laminate worktop upstands is a relatively straightforward task. First cut your upstand to size using a saw, jigsaw or circular saw, before attaching to the wall using a water-resistant silicone. Edges will need to be refinished using easy to apply edging strips.

How do you cut a sink hole in a laminate countertop?

Cutting a Hole in a Countertop for the Sink Drill two starter holes in opposite corners just inside the cutting line. Use a 3/4-inch spade bit and drill through the laminate and substrate. Place the blade of the jigsaw in the starter hole and line up the blade exactly on the cutting line. Cut slowly along the line.

What kind of saw blade do you use to cut laminate counter top?

circular saw blade

Will Home Depot cut laminate countertops?

Your local Home Depot store’s kitchen design center can partner with you to purchase and to cut the piece of countertop you’d like. You didn’t specify what material you’d like the countertop to made from (laminate, Corian, natural stone, etc.), so this can greatly affect the price and how it can be cut.

How do you put end caps on laminate countertops?

Cover the cut area with a laminate endcap that matches the surface of the laminate countertop. Place the countertop on a flat and stable work surface. Cover the exposed end of the countertop with a layer of wood glue. Brush a layer of contact adhesive over the buildup strip and the back of the laminate endcap.

Does IKEA cut countertops?

All of IKEA’s wooden countertops are pre-cut, which means you can take them home from the store.

How do you cut a laminate countertop without a router?

Cut the laminate sheeting down to size to fit the countertop with a circular saw or a fine-toothed handsaw. Give yourself an extra inch on both dimensions — you can trim the excess later. Paint a layer of contact cement on the surface of the countertop and on the back of the laminate sheeting.

How do you attach laminate countertops?

Measure and cut the laminate countertops to the desired size. When connecting two pieces along a run, such as in a galley kitchen, make the cuts straight across at a 90 degree angle. For joining in a corner, the pieces should be cut at a 45 degree angle. Sand down any rough edges with a sander or file.

How do you cut a formica sheet without chipping it?

If you’re forced to cut a laminate sheet from the front with a power saw, you can avoid chipping by laying masking tape along the cutline, sawing through the tape, and removing it after you’re done. You can further minimize chipping by using a plywood-cutting blade with a large number of teeth.